December 10, 2007 - Ah, a 3-day weekend with no plans.
Time for a whole lot of work on the car, right?
Well, I did get the navigator's footrest installed. This is the one that was donated by Jason over on the Grassroots Motorsports forum. Thanks again, Jason! My original design for the bracket was made of steel tube. I took a second look before starting up the welder, and realized I could do better. The rear support is aluminum angle, putting the strength where I need it. The side brackets have a couple of holes so I can adjust the angle of the footrest, remove the whole thing or simply lower the main plate to get access to whatever's behind it. It's nice and solid and probably 1/4 the weight of the original plan. I'm pretty happy with this.
I also discovered that the switch for raising and lowering the headlights is double-throw, so I've ordered a few switches to allow me to wire the car properly and this has put off the installation of the switch panel. I've also been doing some research into header collectors, more on that later.
So, what else got done? Well, the master bedroom in the house has been repainted. Didn't see that coming, did you?
tags: weight loss, ergonomics |
THE DIARY