Targa Miata
MIATA BUILD
Click to see the next entry
July 29, 2007 - The big masking job begins.
It's tricky masking a convertible with a roll cage and no glass. The masking paper I bought from the paint store makes the job a lot easier than it could be. I thought about using plastic but I'm pretty sure this was the right decision.
One thing I did realize is that the hardtop complicates things. The top covers some of the rear fender when it's installed, so I have to paint the stripes on the topless car. But that's going to make it very difficult to align the stripes properly on the hardtop, and it's pretty obvious I can't pop it on and off when the car is masked. So I'll paint stripes on the car and the base color on the hardtop. Then I'll unmask the car, install the hardtop, mask off the remaining stripes (cyan and red) and spray it then. It means five painting sessions instead of three, but it'll also mean a much better look when I'm done.
I will mask off the wheels properly before spraying, and I might extend the "skirt" right to the floor. I sure hope this tape gives a clean edge. Not that I'm worried.
tags: Martini